Clifton Campus Infrastructure Works

Clifton Campus Infrastructure Works - Overview Introduction The following is a brief description of the works to be carried out as part of the Clifton Campus project. This overview is intended to give an indication of the works to be carried out and should be read in line with the appropriate tender documents.

This overview is for info only and does not supersede the requirements set out in the tender documents. Project description The Clifton Campus is undergoing further development both current and future project will require existing below ground services to be diverted away from building footprints and up grading to account for the additional loads.

These works are for the alterations/diversions required to the existing gas, water and HV/LV electrical services that currently run below the footprint of the ongoing ISTEC development plus the diversions necessary for a proposed future development currently below a tarmac car parking area. In addition the university in currently in the process of construction an energy centre on the Clifton campus adjacent to the Erasmus Darwin building which is to be used to serve the heating requirements of all potential new building and the existing buildings Ada Byron King and Rosalind Franklin. There works will involve extensive trenching and making good to existing services which all form part of this tender, while grounds are open and to improve the university’s IT resilience additional IT ducts as detailed are to be installed and connected into existing chambers where stated. Appropriate systems are to be installed to enable the remote live monitoring and data logging of the system including the monitoring of the performance of each pump located in the plant rooms (heat use, temperature, and flow), to give the energy used by the individual buildings. Works are proposed to start on site XXXX 2016. Scope of work The works will include, but are not limited to: • The adoption of the Principal Designer and Principal Contractor roles in accordance with the CDM Regulations • Trenching works as per the drawing details. • Diversion of buried services where required. • Construction of a concrete base for the HV Sub-Station and diesel standby generator. • Supply and erection of a prefabricated GRP housing for Transformer, Ring main Unit, LV panel, etc. • Diversion and jointing of section of existing H/V ring. • Supply and install of LV supplies. • Supply and install of new Gas and Water Services. • Supply and install of LTHW distribution system. • Supply and install of IT, Telecoms, BEMS, Security and fire alarm ducts. • Supply and install of PHE, LLH, pump sets and ancillary equipment to 2 off existing plant rooms. • Supply and installation of all associated controls for plant rooms, small power, metering and monitoring equipment. • Making good • Coordination of all associated works •

Additional information: This tender is being administered through the University's Intend tendering portal. All correspondence and tender returns should be sent through Intend. Once registered, select current tenders and the relevant tender. To get access to the tender documents, click on the express an interest button and then select ITT.