ESS Circulators and Loads

The mandate of the European Spallation Source ERIC is to design, plan, construct, commission, operate and decommission the European Spallation Source (ESS). It is located in Lund, Sweden, co-hosted by Sweden and Denmark and has more than 17 Partner Countries, including the UK. The UK contribution is coordinated by STFC. The facility will deliver its first neutrons in 2019 and is expected to be fully operational by 2025. The European Spallation Source (ESS) will be one of the largest infrastructures in Europe and will be used for neutron production for materials research. It will use a long pulsed superconducting linac and accelerate a 62.5 mA proton beam current to the energy of 2000 MeV. Peak beam power to the target will be 125 MW, 7 times more than the highest power existing facility. STFC are providing a number of goods and services on behalf of the ESS. . This tender is for components of the RF distribution system (RFDS) for the Spoke, Medium beta elliptical and High beta elliptical cavities. The supply shall comprise the components of the RFDS. The number of WR1150 circulators and loads required for MB is confirmed at 36, the number for HB is currently being reviewed. The supplier should therefore give costs for the range 36 to 120 circulators and loads to be supplied. The actual number required will be known before Contract signature. Note that the MB and HB circulators and loads are the same.

Additional information: I would like to notify you that this procurement opportunity is currently live on Tenders Electronic Daily, a copy of the Notice is attached and, if you have not already taken the opportunity to register, instructions are detailed below on the process for registration and expression of interest via Crown Commercial Service's e-Sourcing Suite. This procurement will be managed electronically via the Crown Commercial Service's e-Sourcing Suite. To participate in this procurement, participants must first be registered on the e-Sourcing Suite. If Bidders have not yet registered on the eSourcing Suite, this can be done online at https://gpsesourcing.cabinetoffice.gov.uk by following the link 'Register for CCS eSourcing'. Please note that, to register, Bidders must have a valid DUNS number (as provided by Dun and Bradstreet) for the organisation which you are registering, who will be entering into a contract if invited to do so. Full instructions for registration and use of the system can be found at http://ccs.cabinetoffice.gov.uk/i-am-supplier/respond-tender Once you have registered on the eSourcing Suite, a registered user can express an interest for a specific procurement. This is done by emailing [email protected]. Your email must clearly state: the name and reference for the procurement you wish to register for; the name of the registered supplier; the name and contact details for the registered individual sending the email. Crown Commercial Service (CCS) will process the email and then enable the Bidder to access the procurement online via the e-Sourcing Suite. The registered user will receive a notification email to alert them once this has been done. As a user of the e-Sourcing Suite you will have access to Emptoris email messaging service which facilitates all messages sent to you and from you in relation to any specific RFX event. Please note it is your responsibility to access these emails on a regular basis to ensure you have sight of all relevant information. For technical assistance on use of the e-Sourcing Suite please contact Crown Commercial Service (CCS) Helpdesk : Freephone: 0345 010 3503 email: [email protected] Training support to respond to a requirement is available to bidders at http://www.uksbs.co.uk/services/procure/Pages/supplier.aspx